Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
4.
Select [Flash group].
5.
Set the firing group.
Select [Fire all (no separate control)], [A:B], or [A:B:C], and then
[OK].
• For the same output from all receivers, select [Fire all (no
separate control)].
• To set the output for firing groups A and B, select [A:B].
• To set the output for firing groups A, B, and C, select [A:B:C].
6.
Select a firing group.
Select the group to which the flash output applies.
51