Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
Setting the flash output and flash exposure compensation amount
Configure flash features available in the flash mode.
For [Manual flash], set the flash output. For [E-TTL II] or
[AutoExtFlash], set the flash exposure compensation amount as
needed.
Repeat step 4 to configure flash features for all firing groups.
Caution
For [AutoExtFlash] flash mode, make sure the receivers support auto external
flash metering. Firing in this flash mode is not possible if auto external flash
metering is not supported.
In [E-TTL II] or [AutoExtFlash] flash mode, exposure is controlled to obtain
standard exposure for the main subject as if using a single group, which may cause
overexposure if multiple firing groups are pointing toward the main subject.
Note
For details on [AutoExtFlash], refer to the instruction manual of flash units that
support auto external flash metering.
The order of firing among firing groups does not need to be consecutive; for
example, A, C, E can be set.
Set any group you do not wish to fire to [Disable] when setting the flash mode in
step 3.
61