Owner's Manual
Table Of Contents
- Advanced User Guide
- Contents
- Introduction
- Getting Started
- Wireless Flash Photography
- Wireless Settings
- ETTL: Fully Automatic Wireless Flash Photography
- Advanced Shooting with Fully Automatic Wireless Flash
- Using Multiple Senders
- ETTL: Wireless Multiple-Flash Photography with Flash Ratio
- M: Wireless Multiple-Flash Photography with Manual Flash Output
- Gr: Shooting in a Different Flash Mode for Each Group
- Clearing Transmitter Settings
- Test Firing from Receivers
- Remote Release from Receivers
- Setting Transmitter Functions from the Camera
- Customizing the Transmitter
- Reference
- Basic Instructions
- Warranty
Settings Available in [External Speedlite control]
The configurable functions are as follows. Available settings vary depending on the camera
and flash mode used, wireless function settings, and other conditions.
Function
Flash firing Enable / Disable
E-TTL balance Ambience priority / Standard / Flash priority
E-TTL II meter. Eval (FacePrty) / Evaluative / Average
Contin flash ctrl E-TTL each shot / E-TTL 1st shot
Slow synchro
Flash mode
E-TTL II flash metering (autoflash) / Manual flash / MULTI
flash (stroboscopic) /
Individual group control
Wireless functions Wireless:Radio transmission
Shutter synchronization
First-curtain synchronization / Second-curtain
synchronization / High-speed synchronization
Flash exposure compensation
Flash exposure bracketing
Clear settings
Flash firing
For wireless flash photography, set to [Enable]. Setting to [Disable] disables wireless
flash photography.
E-TTL balance
You can set the finish (taste) of the flash photo according to your preference. This
setting enables you to adjust the ratio of ambient light to flash unit light output.
E-TTL II meter.
Set to [Eval (FacePrty)] for flash metering suitable for shots of people. High-speed
continuous shooting is slower than when [Evaluative] or [Average] is selected. Set to
[Evaluative] for flash metering that emphasizes firing in continuous shooting. If
[Average] is set, flash exposure is averaged for the entire metered scene. Flash
exposure compensation may be necessary depending on the scene.
Contin flash ctrl
Set to [E-TTL each shot] to perform flash metering for each shot. Set to [E-TTL 1st
shot] to perform flash metering for only the first shot before continuous shooting. The
flash output level for the first shot is applied to all subsequent shots. Useful when
prioritizing continuous shooting speed without recomposing shots.
69