Operation Manual

121
Menu Settings
Advanced Guide Menu Settings
Main factory defaults
System settings
Submenu Default Value
User screen settings
Logo capture Cancel
Logo position Center
No signal screen Blue
Screen when blank Black
Projector on Canon logo
On screen
Menu position Center
Menu display time Normal
Guide On
Show input status On
Lamp warning display On
Air filter warning
display
On
Overheat warning
display
Off
Remote control/Side control
Beep On
Key repeat On
Key lock Off
Remote control
channel
Independent
Audio in terminal select
DVI-1 Audio in
DVI-2 Audio in
DVI-3 Audio in
DVI-4 Audio in
DVI 1x2 Audio in
DVI 2x2 Audio in
Network settings
Submenu Default Value
DVI 1x4 Audio in
HDMI-1 HDMI-1
HDMI-2 HDMI-2
HDMI 1x2 HDMI-1
Power management
mode
Standby
Power management
duration
15 min.
Direct power on Off
Motion blur reduction Off
Other settings
Password settings Off
Adjust panel characteristics
Gamma restore Off
Adjust panel
temperature
Off
Submenu Default Value
Network settings lock Lock
Network password
setting
On
Network standby settings Low-power
Network function Off
Detailed settings
DHCP Off
PJLink On
AMX Device Discovery Off
Crestron RoomView Off
This function does not reset the following values.
- Selected input signal - Lamp counter - Language
- Remote control channel - Network settings - Air filter counter
- Lens - Position - Professional settings (Registration, Advanced
registration, High altitude, Vertical projection)
- User profile - Marginal focus setting
value
- Gamma restore
- Adjust panel
temperature
- Power counter