Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
101
Adding Marks to Clips in CAMERA Mode
Adding Marks to Clips in CAMERA Mode
When the main recording format is set to XF-AVC, while recording, you can add shot marks (!) to flag an
important shot or frame. After recording a clip, you can add an OK mark ($) or check mark (%) to help you
identify particular clips.
You can add and delete marks also in MEDIA mode (A 137, 137).
Marks cannot be added to proxy clips.
Adding a Shot Mark while Recording
To add a shot mark to a clip while recording, you must set an assignable button to [Add Shot Mark] in advance.
1 Set an assignable button to [Add Shot Mark] (A 115).
2 While you are recording, press the assignable button at the beginning of the shot you wish to mark.
• [Shot Mark] will appear briefly and the shot mark will be added to the current frame of the clip.
NOTES
NOTES
• Up to 100 shot marks can be added to a single clip.
• There may be up to a 0.5 second delay from when you press the button to when the camera adds the shot
mark.
• When a clip contains a shot mark, ! will appear next to the clip’s thumbnail in the playback index screen.
• When pre-recording is activated, you cannot add a shot mark before the REC button is pressed, or during
interval recording or frame recording.
Adding an $ Mark or % Mark to the Last Clip Recorded
$ marks can be used to protect important clips, as clips with an $ mark cannot be deleted with the camera.
To add a mark in CAMERA mode, you must set an assignable button to [Add $ Mark] or [Add % Mark] in
advance.
1 Set an assignable button to [Add $ Mark] or [Add % Mark] (A 115).
2 After recording a clip, press the assignable button.
•[$Mark] or [%Mark] will appear briefly and the selected clip mark will be added to the clip.
NOTES
NOTES
• A clip cannot have both an $ mark and a % mark at the same time.
• When a clip has an $ mark or % mark, the respective icon will appear next to the clip's thumbnail in the
playback index screen.