Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
Using Metadata
104
• Automatically, > [
Æ
Recording/Media Setup] > [Metadata] > [Add XML File] will be set to [On], and
[XML File Format] will be set to [News Metadata].
• Only the most recently transferred file can be saved.
Resetting News Metadata
You can reset the News Metadata added to clips.
1 Select > [
Æ
Recording/Media Setup] > [Metadata] > [News Metadata Reset All].
2 Select [OK].
IMPORTANT
• When the camera is turned off normally, the News Metadata file is saved or a previously saved News Metadata
is reset. In the case of a power outage or if the power is not terminated normally the file will not be saved or
reset.
• News Metadata saved to the camera will be reset if you select > [
B
System Setup] > [Reset] > [All
Settings], or if the camera's firmware is updated.
Entering Slate Information About the Recording
You can enter scene and take information to help identify the recording later on.
1 Select > [
Æ
Recording/Media Setup] > [Metadata] > [Scene] or [Take] > [Change].
2 Enter the desired text using the keyboard screen (A 27).
• To clear the scene/take information, select [Reset] instead.