Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
151
Applying a LUT/the View Assistance Function to the LCD Screen
3 Select the LUT file on SD card B.
4 Select the color space for the output signal ([Color Space (Output)]).
• To leave the color space unchanged, select [Do Not Convert] instead.
5 Select the output range ([Range (Output)]).
6 Select [OK].
• The selected LUT file will be registered in the camera.
Applying a User LUT
1 Select > [¢ Monitoring Setup] > [LUT: SDI] > [On]
2 Select > [¢ Monitoring Setup] > [LUT Selection: SDI] > Desired option.
• After registering a user LUT, it will appear as one of the options ([USERLUT1¥] to [USERLUT4¥]) when
you select the desired LUT.
• Only registered user LUTs are listed in the options.
Deleting a User LUT
1Select
> [¢ Monitoring Setup] > [User LUT 1] to [User LUT 4] > [Delete] > [OK].
• The selected user LUT will be deleted.
Resetting All the User LUTs
1Select
> [¢ Monitoring Setup] > [Reset All User LUTs] > [OK].
• All user LUTs will be deleted.
Renaming a User LUT
You can rename each of the four user LUTs in the camera.
Select > [¢ Monitoring Setup] > [User LUT 1] to [User LUT 4] > [Rename].
• Enter the desired LUT name (up to 8 characters) using the keyboard screen (A 27).
Checking a User LUT’s Settings
Select > [¢ Monitoring Setup] > [User LUT Info] > Desired user LUT.
NOTES
• User LUT files in the camera cannot be overwritten. If necessary, delete a user LUT file in the camera before
registering a different LUT file.
Applying the View Assist Function
1 Select > [¢ Monitoring Setup] > one of the [View Assist:] settings > [On] or [On (BT.709)].
• The view assistance function is applied and the gamma curve and color space of the displayed image will
change.
• The signal output will use narrow range (video range) coding.
• You can also adjust this setting using direct touch control (A 49).
2 Select > [¢ Monitoring Setup] > One of the [Select View Assist:] settings.
• When only one option is available, it will be grayed out.