Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
Applying a LUT/the View Assistance Function to the LCD Screen
152
NOTES
• Setting [View Assist: HDMI] to [On (BT.709)] disables the > [
¢
Monitoring Setup] > [Range: HDMI] setting.
• The colors modified by using this function are an approximation, and differ from the colors obtained when you
set [Gamma/Color Space] in the custom picture file (A 123) to [BT.709 Wide DR / BT.709].
• The colors in the dark areas / highlights of the image may not be displayed accurately.
Adjusting the Gain Difference When Converting HDR to SDR
When the video displayed on the screen or recorded as a proxy clip is set to HDR* and a LUT is applied, you can
adjust the difference in gain between the SDR output relative to the HDR image (±7.5 dB in 0.5 dB intervals).
* When the [Gamma/Color Space] setting in the custom picture file is set to [PQ / BT.2020] or [HLG / BT.2020], or when the
[Gamma/Color space] setting after applying a Look File is set to [HDR PQ (BT.2100)] or [HDR HLG (BT.2100)].
Select > [¢ Monitoring Setup] > [Gain for HDRSDR Conv.] > Desired option.