Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
Network functions and connection types
158
NOTES
• Do not open the card compartment cover while using network functions.
• Do not place cables connected to the camera’s SDI OUT terminal or HDMI
OUT terminal, INPUT terminals, MIC terminal or USB terminal near the built-in
wireless antenna. Doing so may negatively affect the wireless communication
or the audio recorded.
Using a Wi-Fi Network
Wi-Fi Connection Types
You can connect the camera in Infrastructure mode, using an access point (wireless router etc.), or in Camera
Access Point mode, directly to a network device. The type of connection you can use, depends on the network
function you wish to use (A 157).
For an Infrastructure connection, the camera offers 4 ways to configure an access point and the method you use
will depend on the type and specifications of the access point and network you plan to use.
Camera Access Point: When shooting in a location where there are no access points available, the camera can
serve as a wireless access point*. Wi-Fi enabled devices will be able to connect to the camera directly.
* Limited only to the connection between the camera and supported Wi-Fi enabled devices. The functionality is not the same as
that of commercially available access points.
Infrastructure connection:
WPS (button): If your wireless router supports Wi-Fi Protected Setup (WPS), setup will be
easy and require minimal configuring and no passwords. To check if your wireless router
has a WPS button and for details about how to activate the Wi-Fi protected setup, refer to
the instruction manual of your wireless router.
WPS (PIN code): Even if your wireless router does not have a dedicated WPS button, it may support WPS using
a PIN code instead. For setup using a PIN code, you will need to know in advance how to activate the wireless
router’s WPS function. For details refer to the instruction manual of your wireless router.
Searching for Access Points: If your access point does not support the WPS function or you are using a
smartphone's mobile connection (tethering), you can have the camera search for access points in the area.
Entering the SSID and authentication method: Manually enter the SSID and other information about the access
point.
IMPORTANT
• Depending on the country/region of use, some restrictions on outdoor use or Camera Access Point
connections may apply when using the IEEE 802.11b/g/a/n/ac wireless standard. Check the applicable areas
of use and restrictions in advance (A 225).
Built-in wireless antenna