Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
165
Configuring Connection Settings
2 Make sure the Ethernet cable is correctly connected (A 159) and select [Setup with Network Connection].
• Select [Setup without Network Connection] to only configure the settings, without connecting to the
network.
3 Set the IP address (A 167).
4 Select [OK] to continue to configure the function settings.
• The communication settings are saved to an [NW] file.
• Continue with one the following procedures to configure the selected function’s settings.
FTP transfer (A 161), IP streaming (A 163), Browser Remote (A 164)
Camera Access Point
Connect a network device with the camera’s access point. Two configuration methods are available: easy
connection and manual connection.
1 In the [Select a network] screen, select [Camera Access Point Mode].
2 Select the configuration method.
• Depending on the selected method, perform either step 3 or steps 3-7 and then continue to step 8.
[Easy Connection]
3 The camera will assign the network name (SSID) and password automatically. Review the settings for the
camera’s Wi-Fi access point and select [OK].
• These settings are necessary to connect a network device to the camera.
• QR code connection is also possible. Touch [QR] on the screen to display a QR code to be read with a
network device.
[Manual Connection]
3 Enter the SSID (network name) for the Camera Access Point and then select [OK].
• Enter the desired network name using the keyboard screen (A 27).
4 Select the Wi-Fi channel.
• Select [Automatic Setting] to have the camera select the channel automatically, or select [Manual Setting] >
Desired channel.
5 Select the encryption settings.
• Select [AES] to use AES encryption, or [Disable] to use no encryption.
• If you selected [Disable], skip to step 7.
6 Enter the password for the Camera Access Point and then select [OK].
• Enter the desired password using the keyboard screen (A 27).
7 Set the IP address (A 167).
Both configuration methods
8 Select [OK] to continue to configure the function settings.
• The communication settings are saved to an [NW] file.
• Continue with one the following procedures to configure the selected function’s settings.
FTP transfer (A 161), Browser Remote (A 164)
9 Before you can save the connection setting, connect the network device to the camera.
• Activate the device’s Wi-Fi function, select the camera’s SSID (network name) from the list and enter the
password to connect to the camera.