Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
169
Configuring Connection Settings
Changing Settings using the Wizard
1 Select > [ Network Settings] > [Connection Setting] > Desired connection setting ([SET1] to
[SET20]) > [Change with Wizard].
2 Select the desired network function and then follow the wizard as described in the previous procedure (from
step 3, A 161) and make any changes as necessary.
Changing Connection Settings using Existing Settings
You can use previously registered communication settings ([NW] files) or function settings ([MODE] files) to easily
replace the content of a connection setting or to add a second network or network function in addition to those
registered using the wizard.
1 Select > [ Network Settings] > [Connection Setting] > Desired connection setting ([SET1] to
[SET20]) > [Select Existing Setting].
To add/replace a communication or function setting
2 Select the setting you want to change > [Select Existing Setting] > Desired NW or MODE file.
• In the list of communication settings and function settings registered in the camera, only those that can be
selected will be displayed in white and others will be grayed out.
3 Select [Set].
• If necessary, select [Check Comm. Settings] or [Check Function Settings] to check the content of the
selected file before making the change.
To delete a communication or function setting
2 Select the setting you want to remove > [Clear Selected] > [OK].
NOTES
• A connection setting can have two communication settings (primary/secondary network) and up to two
function settings (only for [IP Streaming] and [Browser Remote]).
• If both communication settings are deleted, the connection setting itself will be reset and will appear as
[Unspecified].
Renaming Connection Settings
You can rename connection setting (SET) files to make them easier to identify from the list.
Select > [ Network Settings] > [Connection Setting] > Desired connection setting ([SET1] to [SET20])
> [Settings Name].
• Enter the desired name (up to 12 characters) using the keyboard screen (A 27).
Deleting Connection Settings
Select > [ Network Settings] > [Connection Setting] > Desired connection setting ([SET1] to [SET20])
> [Delete Settings] > [OK].
• The connection setting will be deleted.
NOTES
• Even if you delete a connection setting, the individual communication/function settings stored in it are not
deleted. You can reuse these settings to configure other connection settings.