Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
Configuring Connection Settings
170
Checking and Changing Communication Settings (NW)/Function Settings (MODE)
You can check the content of communication settings ([NW] files) and function settings ([MODE] files) saved in
the camera and change or delete them as necessary.
Checking the Content of a Communication Setting/Function Setting
1 Select > [ Network Settings] > [Advanced Settings] > [Communication Settings] or [Function
Settings].
2 Select the desired communication setting ([NW1] to [NW25]) or function setting ([MODE1] to [MODE25]).
3 Select [Check Settings].
• The detailed content of the selected setting is displayed.
• Push the joystick left/right to review all the settings and press the CANCEL button to return to the menu.
Changing/Deleting Communication Settings/Function Settings
1 Select > [ Network Settings] > [Advanced Settings] > [Communication Settings] or [Function
Settings].
2 Select the desired communication setting ([NW1] to [NW25]) or function setting ([MODE1] to [MODE25]).
3 Select [Change Settings] and change the various settings as necessary.
• If in step 2 you selected an [Unspecified] settings file, the only option available is [Create New with Wizard]
(A 161).
• Select [Delete Settings] > [OK] to delete the communication setting/function setting.
Configuring TCP/IPv6 Settings
If in the wizard you selected [Enable] to use IPv6 settings, change the settings as necessary after completing the
wizard.
1 After step 3 in the previous procedure, select [TCP/IPv6] > [TCP/IPv6 Settings] > [Enable].
• This step is not necessary if you selected [Enable] when you used the wizard to add a new connection
setting.
• Continue the procedure to change the default IPv6 settings.
2 To configure the IPv6 settings manually, select [Manual Setting] > [Enable].
• [DNS Server] changes to [Manual Setting].
3 Select [DNS Server] > Desired option.
• If you selected [Disable] in step 2, you can set [DNS Server] to [Auto Assign].
• When not using a DNS server, select [Disable].
4 If you set [DNS Server] to [Manual Setting] in step 3, configure the [DNS Address].
• Enter the IP address using the data entry screen (A 27).
When [Manual Setting] is set to [Enable]
5 Select [Manual Address] (manually entered IPv6 address), [Prefix Length] (bits available for the network
address) and [Gateway] (gateway’s IP address) and enter the necessary information.
• Enter the IP addresses and prefix length using the data entry screen (A 27).