Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
Preparing the Power Supply
20
NOTES
• We recommend charging the battery in temperatures between 10 ºC and 30 ºC (50 ºF and 86 ºF). Outside the
temperature range of 0 ºC to 40 ºC (32 ºF to 104 ºF), charging will not start.
• If there is a malfunction with the battery charger, AC adapter or battery, the charge indicator will go out and
charging will stop.
• For handling precautions regarding the battery, refer to
Handling Precautions
(A 219).
• For approximate charging times / usage times, refer to the
Reference Tables
(A 228) and
Approximate
Continuous Recording Times
(A 226).
• Charged batteries continue to discharge naturally. Therefore, charge them on the day of use, or the day
before, to ensure a full charge.
• We recommend that you prepare batteries to last 2 to 3 times longer than you think you might need.
• Repeatedly charging and completely depleting a battery will eventually shorten its battery life. You can check
the battery life on the [B System Setup] status screen (A 202). Fully charging the battery and then depleting
it completely will give you a more accurate reading.
Attaching the Battery
1 Turn off the camera.
2 Insert the battery all the way into the compartment as
shown in the illustration and press it gently downwards
until it clicks.
Removing the Battery
1 Turn off the camera.
2 Holding down the BATTERY RELEASE button (햲), slide
the battery upwards and then pull it out (햳).
햲
햳
햲
햳