Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
Preparing the Camera
30
Attaching and Removing the Eye Cup
Attach the eye cup so that it covers the rubber rim of the viewfinder
unit. To remove the eye cup, pull it gently in a “peeling off” motion
from the bottom up.
• For left eye use, attach the eye cup so that the protruding part
faces the opposite side.
IMPORTANT
• Pointing the viewfinder lens at the sun or other strong light sources may
cause damage to internal components. When you are not using the
viewfinder, make sure to attach the viewfinder cap to the viewfinder. This will
also protect the viewfinder from scratches and dirt. Attach the viewfinder cap
by inserting it into the rubber rim of the viewfinder unit.
Attaching an Accessory Compatible with the
Multi-Function Shoe
For details on how to attach and use accessories, refer to
the instruction manual of the accessory in use.
Remove the multi-function shoe cover (햲) and slide the
accessory's connecting terminal into the multi-function shoe
(햳).
• When attaching accessories that communicate through
contacts of the multi-function shoe, insert the accessory's
mounting foot until it clicks into place, then slide the
mounting foot locking lever to secure it.
IMPORTANT
Protecting the multi-function shoe:
• After removing accessories from the multi-function shoe, reattach the shoe cap to protect the contacts from
dust and water.
• Blow off any foreign material on the multi-function shoe with a commercially available blower or similar tool.
• Allow the multi-function shoe to dry before use if it gets wet.
NOTES
• The Electronic Viewfinder EVF-DC2/EVF-DC1 cannot be attached to the multi-function shoe. Attempting to
attach it by force may damage it or the multi-function shoe.
Eye cup
Viewfinder
unit
햲
햳