Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
43
Recording Video and Photos
Onscreen Displays
Refer to this section for an explanation of the various screen displays that appear in CAMERA mode. You can
use the custom display function (A 191) to turn off individual onscreen displays if they are not required. The
menu item that controls each display is given in the following tables (1: indicates a menu item under [Custom
Display 1] and 2: indicates a menu item under [Custom Display 2]).
The position of some icons and onscreen displays may change depending on the display level settings, which
can be set to level 1, level 2 or level 3. The following screenshot and tables describe the onscreen displays at
display level 1 with the [All Displays] setting (A 46).
AF frames
You can turn AF frames on/off with the > [
¢
Monitoring Setup] > [Custom Display 1] > [Focus Mode]
setting.
Continuous AF frame – in white
when [AF Frame] is set to either
[Large] or [Small] (A 77)
AF-Boosted MF frame – in yellow:
manual adjustment range; in white:
automatic adjustment range; in red:
nearer focus is not possible. (A 76)
Face AF: Main subject (A 78)
Face AF:
Only one face detected or faces
other than the main subject
Tracking: Subject selection (A 80)
Tracking: During tracking
Eye detection: Main subject's
eyes (A 78)
Frame shown when focus adjustments
are not possible: in red. You cannot
focus nearer when [AF Mode] is set to
[Continuous] and [AF Frame] is set to
[Whole Area].
Focus guide frame