Owner's Manual
Table Of Contents
- Safety Instructions
- Table of Contents
- 1. Introduction
- 2. Preparations
- 3. Recording
- Recording Video and Photos
- Adjusting Camera and Recording Settings
- Video Recording Configuration: Video Format, System Frequency, Resolution and Frame Rate
- Proxy Clips
- Sub Recording Clips
- Shutter Speed
- ISO Speed/Gain
- ND Filter
- Aperture
- White Balance
- Zoom
- Focus
- Image Stabilization
- Onscreen Markers, Zebra Patterns and False Color
- Setting the Time Code
- Synchronizing with an External Device
- Recording Audio
- Audio Format for MP4 Clips
- Recording Audio Using the Second Card Recording Functions
- Connecting an External Microphone or External Audio Input Source to the Camera
- Selecting the Audio Input Source for Audio Channels
- Adjusting the Audio Recording Level
- Advanced Audio Input Settings
- Monitoring the Audio with Headphones
- Colors Bars/Audio Reference Signal
- Video Scopes
- Adding Marks to Clips in CAMERA Mode
- Using Metadata
- Special Recording Modes
- Infrared Recording
- Using the RC-V100 Remote Controller
- Recording Remotely Using an NU Protocol Compatible Device
- Web Camera Function
- 4. Customization
- 5. Playback
- 6. External Connections
- 7. Network Functions
- 8. Additional Information
Adjusting Camera and Recording Settings
50
Changing Camera Settings
1 Touch the setting you want to adjust, then select the desired value/
setting.
• Once the settings menu is displayed, touch to select the desired
value/setting as needed.
• When the slider appears, drag the slider left/right or touch the /
buttons to adjust the desired value.
2Touch K.
Using Assistance Functions
1Touch A (assistance functions) and then turn assistance functions
on/off, or select the desired assistance function.
2Touch K.
Changing Recording Settings
1Touch Æ (Recording Settings)
• The recording settings menu will be displayed. There are three
pages that can be switched by swiping left and right.
2 Select the desired menu setting and then select the desired option.
3Touch X.
Direct Setting Mode (FUNC Button)
You can adjust main camera functions—white balance, aperture, ISO
speed/gain and shutter speed—using the FUNC button (direct setting
mode). This section will explain the basic operation of the direct setting
mode. For details about each function, refer to the respective section on
the manual.
1Press the FUNC button.
• The onscreen display of the selected function will be highlighted in
orange.
• Press the FUNC button repeatedly or push the joystick left/right to
select a different function.
2Push the joystick up/down to select the desired value or white
balance mode.
3Press SET.
• The selected value/mode will be set and direct setting mode will end.
• The onscreen display of the selected function will return to normal.
NOTES
NOTES
• The camera will automatically end the direct setting mode in the following cases.
- If no operation was performed for more than 6 seconds.
- If the FUNC button is pressed while selecting the shutter speed.
- If the menu or a status screen was opened.
Drag the slider to select the desired value