Owner's Manual

Table Of Contents
64: Cannot connect to wireless LAN terminal
Are the camera and the access point set to use the same encryption method?
The camera supports the following encryption methods: WEP, TKIP, and AES ( ).
If filtering by MAC address is active, is the MAC address of the camera in use
registered at the access point?
Register the MAC address of the camera used to the access point. The MAC
address can be checked on the [MAC address] screen ( ).
65: Wireless LAN connection lost
Are any obstacles blocking the line of sight between the camera and the antenna
of the access point?
Move the antenna of the access point to a position clearly visible from the point of
view of the camera.
The wireless LAN connection was lost, for some reason, and the connection
cannot be restored.
The following are possible reasons: excessive access to the access point from
another device, a microwave oven or similar appliance in use nearby (interfering
with IEEE 802.11b/g/n (2.4 GHz band)), or influence of rain or high humidity.
91: Other error
A problem other than error code number 11 to 83 occurred.
Turn the camera's power switch off and on.
121: Not enough free space on server
The target Web server does not have enough free space.
Delete unnecessary images on the Web server, check the free space on the Web
server, then try sending the data again.
125: Check the network settings
Is the network connected?
Check the connection status of the network.
127: An error has occurred
A problem other than error code number 121 to 126 occurred while the camera is
connected to the Web service.
Try again to establish the Wi-Fi connection to image.canon.
751