Owner's Manual

The access lamp still lights or blinks even when the power switch is set
to < >.
If the power is turned off while an image is being recorded to the card, the access lamp
will remain on or continue to blink for a few seconds. When the image recording is
complete, the power will turn off automatically.
[Battery communication error. Does this battery/do these batteries
display the Canon logo?] is displayed.
Do not use any battery packs other than a genuine Canon Battery Pack LP-E17.
Remove and install the battery again ( ).
If the electrical contacts are dirty, use a soft cloth to clean them.
The battery becomes exhausted quickly.
Use a fully charged battery ( ).
The battery performance may have degraded. See [ : Battery info.] to check the
battery recharge performance level ( ). If the battery performance is poor, replace the
battery with a new one.
The number of available shots will decrease with any of the following operations:
• Pressing the shutter button halfway for a prolonged period
• Activating the AF frequently without taking a picture
• Using the lens's Image Stabilizer
• Using the wireless communication functions
The camera turns off by itself.
Auto power off is in effect. To deactivate auto power off, set [Auto power off] in [ :
Power saving] to [Disable] ( ).
Even if [Auto power off] is set to [Disable], the screen and viewfinder will still turn off
after the camera is left idle for the time set in [Screen off] or [Viewfinder off] (although
the camera itself remains on).
866