Instruction Manual
Wireless Manual Flash With Varied Flash Output
pH mm
—g-
M
^■z. 11 CEnia^/?y
V MODE +
_________
— SEL/SCT ZOOM
I fSE
(ff 11»')
8
Press the <+> or <-> button to set
the flash output for B.
Press the <SEL/SET> button.
• C and the flash output display will blink.
Q Press the <+> or <-> button to set
^ the flash output for C.
HA Press the <SEL/SET > button to
register the settings.
• If there are only two slave units (A and B), steps 9 and 10 may be omitted.
Lil • After you complete the settings, you can check the respective flash output for slave
units A, B, and C by pressing the < + > or < — > button.
• Press the master unit's pilot lamp to test fire the slave units.
[4] Wireless Stroboscopic Flash
After setting up the wireless flash system, you can set stroboscopic flash with
the master unit for wireless stroboscopic flash.
• The firing frequency and flash count will be the same for all slave units. They can be set by
following the procedure on page 46.
• Set the flash output of the slave units in the same way as lor wireless manual flash. See page 71.
• To determine the proper exposure, take test shots and experiment.
73