User`s guide

Recalling Previous Copy Jobs
5-2
5
Memory Features
Recalling Previous Copy Jobs
You can recall the three most recent copy jobs and make copies using these settings.
IMPORTANT
• One copy job is defined by setting the number of copies, exposure, zoom, etc., and by pressing or
, when the Auto Clear function is 'On', or by calling up a copy job stored in memory. If one of these
keys was not pressed, or if the Auto Clear function is not active, calling up a copy job by pressing
[Recall] is not possible.
• The Standard mode cannot be recalled or stored.
• Identical copy modes that are stored, are counted as one setting.
• Even if a remote copy printer is stored in Recall mode, if the main power of this machine or the remote
copy printer is turned OFF and ON again, the stored settings change to Local Printer. To use the stored
remote copy printer, confirm that the remote copy printer is ON, update the remote copy printer
information after the specified period that you set at the Startup Time Settings in Additional Functions,
and set the Recall mode. (See Chapter 3, "Using a TCP/IP Network," in the Network Guide or
"Confirming a Remote Device," on p. 8-21.)
NOTE
• The Recall mode is available for the Copying function only.
• Once stored, the last three copy modes remain in memory after you turn OFF the power.
1 On the Special Features screen, press [Recall].
iR6570_CMB_Upgrade_ENG_Post_Final.book Page 2 Tuesday, May 24, 2005 12:12 PM