User`s guide

Paper Selection

1-29

Introduction to the Copy Functions

Paper Selection

NOTE

•

If you are copying an original with an image that extends all the way to the edges onto the same size

paper at a copy ratio of 100%, the periphery of the original image may be cut off slightly on the copy.

For more information on how much may be cut off, look under the margin areas in the Specifications

table in Chapter 9, "Appendix," in the Reference Guide.

•

If you select the Entire Image mode, the copied image is automatically reduced slightly based on the

copy paper size and the image size. As a result, the entire original image is reproduced on the copy

without being cut off. (See "Entire Image," on p. 3-17.)

•

If you select [Tracing Paper], [Transparency], or [Labels] make sure that you do not specify any Finisher

modes (Collate, Group, or Staple).

•

If Stack Bypass Standard Settings in Common Settings (from the Additional Functions screen) is set to

'On', and the paper size/type have been stored, the selected paper size/type are displayed on the

screen. (See Chapter 4, "Customizing Settings," in the Reference Guide.)

•

For instructions on loading paper into the stack bypass, see Chapter 2, "Basic Operations," in the

Reference Guide.

•

The default setting is 'Auto'.

Place your originals ➞ press [Paper Select].

iR6570_CMB_Upgrade_ENG_Post_Final.book Page 29 Tuesday, May 24, 2005 12:12 PM