Instruction manual

Turn on the
Power Switch
Set the power switch td <ONa .
o-
The flash will start recycling .
Check that the flash is ready .
* The pilot tamp will first turn green [ready for
quick flash], then red (fully recycled or flash
ready) .
w To fire a test flash, press the pilot lamp .
About Quick Flash
Quick flash enables a flash to be fired before flash-ready, when the pilot lamp
is still green-
Although
the
Guide Na . will be 116 to 112 that of the full output, quick flash is
effective for near
subjects and when you want a shorter recycle time .
Set the drive made to Single . Quick flash cannot be used in the continuous
shoaling . FEB, manual flash, and stroboscopic flash modes .
About Auto Power Off
To sage battery
power,
the power will turn off automatically after 90 sec . of
idle use . To
turn on the Speedlite again, press the shutter button halfway .
Or press the Speedlite's test firing
button .
LXl R A test firing cannot 6e fired while the camera's operation timer (1A or
CAS
is active .
~ " The Speedlile's sppings will be mlained in memory even after the power is turned off .
7o retain the Speedlite's settings when you replace the batteries, replace the batteries
within i minute after turning off the power,
10