Instruction manual

Troubleshooting
Hare a prahlem?
See the table below .
The Speedli#e does not detach from
the camera .
c:
The mounting foots locking pin has not been retracted .
Loosen the locking ring all the way before detaching the Speedlite . (p .9)
The
Speedliie does not fire,
~~ The batteries are
installed in the wrong orientation .
~ Install the batteries in the
correct orientation . (p .8)
The Speedliie's infernal batteries are exhausted .
j . If the flash recycling time
is 30 sec . or longer, replace the batteries . [p .8]
Install the Speedlite's internal batteries even when
youuse an external
power source . (p,8)
A Attachthe Speed lite securely to the tamers .
Attach the Speedlite's mounting
foot securely to the camera . (p .9)
The electrical contacts of the Speed lite andcamera are dirty .
1 Clean the contacts . (p .9)
The slave unit does not fire .
0
The slave's
wireless selector is not set to < SLAVE> .
o~
Set it to
<SLAVED . (p .34)
a The slave unit is not positioned properly .
Place the slave unit within the master units transmission range . [p .35]
P, Point
the slave
units sensor toward the master snit . [p .35]
Th
e
power turns off by . itself .
,D After 90 sec . of idle operation, auto power off took effect .
a- Press the shutter button halfway or press the test firing button . (p .10)
The entire LCD panel blinks
.
r
The
wide panel has been pulled out for bounce flash .
s Retract the wide panel . (p .20)
48