Owner's Manual
Table Of Contents
- Instruction Manual
- Compatibility
- Table of Contents
- Parts & Controls
- Installing the Batteries
- Attaching the Flash
- Flash Shooting
- Flash Shooting in Each Camera Mode
- Auto Power Off
- AF-Assist Beam
- Setting the Flash Functions by Camera Operation
- About Wireless Flash
- Wireless Settings
- Fully Automatic Wireless Flash
- Flash Ratio with E-TTL II
- Wireless Multiple Speedlite Shooting with Manual Flash Output
- Troubleshooting
- Specs
- Warranty
26
If you need more flash output or want to perform
advanced lighting, you can increase the number of
slave units. Set an additional slave unit to the firing
group (A, B or C) whose flash output you want to
increase. There is no restriction on the number of
units.
For example, if you set a firing group with three slave
units to <1>, the three units are controlled as a single
firing group A with a large flash output.
About Slave Group Control
ID = A ID = AID = A
Firing group A