Brochure
70
usa.canon.com/eos
71
EOS SYSTEM ACCESSORIES
70
* T3 accessories require Remote Switch Adapter RA-N3 with N3-series cameras.
** EOS RT, 650, 630 and 620 require Grip GR20 with built-in T3 remote socket.
* T3 accessories require Remote Switch Adapter RA-N3 with N3-series cameras.
** EOS RT, 650, 630 and 620 require Grip GR20 with built-in T3 remote socket.
EF 100mm f/2.8L Macro IS USM • f/5.6 • 1/80 sec.
* The EOS 5D Mark III and EOS 7D cameras require a firmware upgrade to be compatible with the GPS Receiver GP-E2. Firmware updates are available on each individual product’s
webpage on the Canon website. See usa.canon.com/consumer for our full line of products.
† In certain countries and regions, the use of GPS may be restricted. Therefore, be sure to use GPS in accordance with the laws and regulations of your country or region. Be particularly
careful when traveling outside your home country. As a signal is received from GPS satellites, take sufficient measures when using in locations where the use of electronics is regulated.
Note:
When the EOS 7D camera is used with the GP-E2 the following restrictions will apply: a) geotagging function will not work for movies while recording; b) geotagging features will not
work for movies when using the Map Utility; c) electronic compass information and automatic time setting is not available; d) transmission via the hot shoe is not possible.
* The WFT-E7A requires a firmware update and Interface Cables IFC-40AB II or IFC-150AB II to work with the EOS 7D Mark II.
** With no obstructions between the transmitting and receiving antennas, and no radio interference. With a large, high-performance antenna attached to the wireless LAN access point.
Wireless File Transmitters and GPS Receivers
Canon Wireless File Transmitters help enable fast, wireless image transfer from EOS cameras
directly to a computer. Canon GPS
†
receivers record location, including latitude, longitude and
altitude, include a compass, and can track the trajectory of the photographer’s movements.
Remote Control & Accessories
Canon accessories are the perfect choice to help enhance your EOS System’s
performance. Whether through recording data or controlling your camera remotely,
Canon’s own accessories are designed to complement your EOS camera.
Wireless File
Transmitter
WFT-E4 II A
Wireless File
Transmitter
WFT-E4A
Wireless File
Transmitter
WFT-E3A
Wireless File Transmitter
WFT-E2A
Compatibility
EOS 5D Mark II EOS 5D Mark II EOS 50D, 40D EOS-1D Mark IV, 1Ds Mark III, 1D Mark III
Description
This wireless transmitter is dedicated to the
EOS 5D Mark II with firmware upgrade. The
transmitter is compatible with Wi-Fi Protected
Setup to connect to a wireless LAN access point
and automatically leads to the security setting
for secure image transfer. Images can be stored
in selected folders and the entire folder can be
transferred. Added functions include IEEE 802.11
a/b/g compatibility, WPS compatibility, camera
linking function, Bluetooth function, media server
function and WFT server Remote Live View. It
allows wireless transmission (802.11a, b or g) to
Mac or Windows computers up to 492 ft.
This wireless transmitter is dedicated to the
EOS 5D Mark II. The transmitter is compatible with
Wi-Fi Protected Setup to connect easily to a
wireless LAN access point and it automatically
leads to the security setting for secure image
transfer. Sending a batch of photos wirelessly is
easy with the WFT-E4A. Images can be stored in
selected folders and the entire folder can be
transferred at once. It retains the same features as
the WFT-E3A including great handling for vertical
shooting and wireless transmission (802.11b
or g) to Mac or Windows computers up to 492 ft.
(150m)** away.
This wireless transmitter is dedicated to the
EOS 50D and 40D camera. Completely integrated
design for outstanding handling; includes vertical
controls. Wireless transmission (802.11b or g)
to Mac or Windows computers. Three separate
wireless methods, including wireless remote
control of camera from computer. Transmits up to
492 ft. (150m)**, depending on environment and
computer set-up; wired Ethernet connection up to
1,000 ft. (330m). Its USB port allows an external
hard drive to be directly connected to the camera.
Canon’s Wireless File Transmitter WFT-E2A allows
photographers to transmit images from cameras
directly to a computer over a wired or wireless
local area network (LAN), incorporates a number of
significant features into a robust, camera-powered
system to make wireless transfer up to 492 ft.
(150m)** faster, simpler and less cumbersome
than WFT-E1A. The WFT-E2A is smaller and attaches
to the side of the camera.
Wireless
Controller LC-5
Remote Switch
RS-80N3
Timer Remote
Controller TC-80N3
Remote Switch
60T3
Compatibility
All EOS cameras except
EOS 70D, 60D, 60Da, EOS M and Digital Rebel
series, 1v Hs, 1v, 3
All EOS cameras except
EOS 70D, 60D, 60Da, EOS M and Digital Rebel
series, 1v Hs, 1v, 3
All EOS cameras except
EOS 70D, 60D, 60Da, EOS M and Digital Rebel
series, 1v Hs, 1v, 3
N3-compatible cameras
*
, with adapter 1N RS, 1N,
1, A2/A2E, RT
**
, 630
**
, 620
**
, 650
**
Description
• An extended-range Wireless Controller system
designed for EOS cameras with N3 remote
control sockets.
• Provides remote shutter release capability.
• Max. transmitter to receiver distance of
300 ft./91.5m
• Remote switch to prevent camera shake for
super-telephoto or macro shots and bulb
exposures.
• Works like a Shutter button, enabling halfway
or complete pressing.
• Shutter release lock.
• Connects to N3-type socket.
• Cord length: 2.6 ft./80cm.
• Remote switch with self-timer, interval timer,
long-exposure timer, and exposure-count
setting feature.
• Timer set from 1 sec. to 99 hrs., 59 min., 59 sec.
• Easy operations with new dial.
• Illuminated LCD panel.
• N3-type connector.
• Cord length: 2.6 ft./80cm.
• Electromagnetic cable release with
a 3-pin terminal.
• Allows independent control of light metering
and shutter release.
• Cord length: 2 ft./60cm.
Remote Switch
RS-60E3
Wireless Remote
Controller RC-1
Wireless Remote
Controller RC-6
Wireless Remote
Controller RC-5
Compatibility
EOS 70D, 60D, 60Da, Rebel T5i, T4i, SL1, T3i, T5,
T3, T2i, T1i, XSi, Digital Rebel XTi/XT, Digital Rebel,
ELAN 7 series, ELAN II/IIE, Rebel T2, Ti, 2000, G, X,
XS, XSN, IX
EOS 5D Mark II, 7D, Rebel T1i, XSi, Digital Rebel
XTi/XT, Digital Rebel, ELAN 7 series, II/IIE, ELAN,
Rebel T2 Date, Ti Date, K2 Date, 10S
EOS 5D Mark III, 6D, 5D Mark II, 7D Mark II, 7D,
70D, 60D, 60Da, EOS M, Rebel T5i, T4i, SL1, T3i,
T2i, T1i, XSi, Digital Rebel XTi/XT, Digital Rebel,
ELAN 7 series, ELAN II/IIE, ELAN, Rebel T2 Date,
Ti Date, K2 Date, IX, 10S
EOS 5D Mark II, 7D, Rebel T1i, Rebel XSi, Digital
Rebel XTi/XT, Digital Rebel, ELAN 7 series, II/IIE,
ELAN, Rebel T2 Date, Ti Date, K2 Date, IX, 10S
Description
• Compact remote switch replicating all the
functions of a shutter release button.
• Cord length: 2 ft./60cm.
• Miniature infrared transmitter.
• Set for either instant shutter release or
2-sec. delay.
• Activate mirror lock and bulb shutter functions.
• Operates as far as 16.4 ft./5m.
• Compact design.
• Operates approximately 16.4 ft/5 m from the
camera.
• Set for either instant shutter release or
2-sec. delay.
• Activate mirror lock and bulb shutter functions.
• Compact design.
• Operates as far as 16 ft./5m from the camera.
Remote Switch
Adapter RA-N3
Remote Switch
Adapter T3
Extension Cord
ET-1000N3
Extension Cord
1000T3
Compatibility
All EOS DSLR cameras except EOS 5D Mark II,
7D, 70D, 60D, 60Da and Digital Rebel series, 1v
Hs, 1v, 3
N3-compatible cameras
*
, EOS 1N RS, 1N, 1,
A2/A2E, RT
**
, 630
**
, 620
**
, 650
**
All EOS DSLR cameras except EOS 5D Mark II,
7D, 70D, 60D, 60Da, 50D and Digital Rebel and
Rebel series, 1v Hs, 1v, 3
N3-compatible cameras
*
, EOS 1N RS, 1N, 1,
A2/A2E, RT
**
, 630
**
, 620
**
, 650
**
Description
• Enables old-model, T3 terminal-equipped
accessories to be connected to cameras with
the N3-type socket.
• Enables use of remote control devices with
standard 2-pin subminiature jacks with
T3-compatible EOS cameras.
• Connects compatible EOS cameras with
Timer Remote Controller TC-80N3 or Remote
Switch RS-80N3.
• Cord length:33 ft./10m.
• Used with any other T3-compatible accessories
for extension.
• Cord length: 33 ft./10m.
Wireless File Transmitter Remote Controllers and Switches
Remote Control Accessories
GPS Receiver GP-E2
†
GPS Receiver GP-E1
†
Compatibility
EOS-1D X, 5D Mark III*, 6D, 7D*, 70D, EOS Rebel T5i, T4i, SL1, T5, EOS M EOS-1D X
Description
The GP-E2 allows photographers to geotag their photos. Its compact, lightweight design smoothly
integrates with the camera’s hot shoe or USB terminal without the need for additional power. The
GP-E2 automatically adds location information as EXIF data while shooting (latitude, longitude,
altitude, direction, universal coordinated time (UTC)). An on-board electronic compass supports
shooting even when held vertically, and the orientation can be displayed on a map with bundled
software. The camera’s clock can be easily set by the GP-E2’s atomic clock. It can also be used as a
stand-alone GPS logger.
To be used with the EOS-1D X, the GP-E1 is Canon’s first GPS Receiver. Its compact, lightweight design
smoothly integrates with the camera’s extension system terminal, allowing the hot shoe to remain
accessible without the need for additional power. The GP-E1 automatically adds location information
as EXIF data while shooting (latitude, longitude, altitude, direction, universal coordinated time (UTC)).
An on-board electronic compass supports shooting even when held vertically, and the orientation can
be displayed on a map with bundled software. The EOS-1D X’s clock can be easily set by the GP-E1’s
atomic clock.
GPS Accessories
Wireless File Transmitter
WFT-E7A
Wireless File Transmitter
WFT-E7A (Version 2)
Wireless File Transmitter
WFT-E6A
Wireless File
Transmitter
WFT-E5A
Compatibility
EOS 5D Mark III, EOS 7D Mark II
*
EOS 5D Mark III, EOS 7D Mark II EOS-1D X EOS 7D
Description
Wireless File Transmitter WFT-E7A transfers images from cameras directly to a computer via wireless local
area networks (LAN), and offers a number of enhanced features to improve efficiency for studios and
media professionals including: wireless support for IEEE 802.11 a/b/g and the latest standard 802.11n,
which deliver blazing communication speed, camera clock synchronization, linked shooting function,
Bluetooth support, and auto re-send of images that were not sent during a sending error.
Canon’s Wireless File Transmitter WFT-E6A is
designed for the EOS-1D X. It transfers images from
cameras directly to a computer via wireless local area
networks (LAN), and offers a number of enhanced
features to improve efficiency for studios and media
professionals including: wireless support for IEEE
802.11 a/b/g and the latest standard 802.11n,
which deliver blazing communication speed, camera
clock synchronization, linked shooting function,
Bluetooth support, and auto re-send of images that
were not sent during a sending error.
This wireless transmitter is dedicated to the EOS 7D.
The transmitter is compatible with Wi-Fi Protected
Setup to connect easily to a wireless LAN access
point and automatically leads to the security setting
for secure image transfer. Images can be stored
in selected folders and the entire folder can be
transferred. Added features include IEEE 802.11a/
b/g compatibility, WPS compatibility, WFT server
EOS 7D, camera linking function and Bluetooth
function. It allows wireless transmission (802.11a,
b or g) to Mac or Windows computers up to 492 ft.
EOS 7D Mark II camera with
Wireless File Transmitter WFT-E7A (Version 2)