User Manual

1　Fit the hood on the front of the lens barrel.

2　Align the index on the hood and lens barrel.

3　Tighten the hood lock knob.

2-3. TURN IT ON

Turn on the camera and power supply equipment on, and the power of the lens will be supplied.

2-2. MOUNT THE HOOD ON THE LENS

The lens cap is attached to the lens at the factory. Please remove the lens cap and attach the

hood as instructed below.

2 HOW TO MOUNT

4　When the lens is mounted, connect the cable from the

drive unit to a power supply

equipment such as camera

or external power supply.

Or if the camera can be powered from the PL mount,

connect the cable from the drive unit to the connector

below the lens mount

* Connect the cable so that the arrow on the connector of the

cable aligns with the arrow of the connector of the lens.

CAUTION

Rated voltage: 12 VDC

Normal operation range: 10 to 17 VDC

If a battery or adapter is used, the output voltage may be higher than the rated voltage depending on the

manufacturers and therefore the above voltages must be observed strictly. If a voltage outside the normal

operation range is used, the drive unit may be damaged.

Index

Hood

Lens Barrel

Hood Lock Knob

S/E1

KAS

CN7x17

NOTE

When connecting and disconnecting the 12-pin

cable, perform it after dismount the lens from the

camera checking it by viewing.