Instruction Manual

2. Affixing the Power Winder to the Camera

• Remove the winder coupler cover of the camera by

unscrewing it with a coin. In order not to lose the cover,

screw it into the winder coupler’s cover holder on the

power winder (except the AL-1).

• Make sure the power winder’s main switch is set to "OFF.”

• Before attaching the Power Winder A2 to the camera, clean

the winder’s and camera’s terminals with a soft cloth to

ensure proper contact.

• Attach the Power Winder A2 to the camera by turning the

fastening screw clockwise with a coin to secure the power

winder to the camera. If it takes a while to fasten the power

winder to the camera while the main switch is set at ‘‘C’’ or

"S," there is a possibility that the warning lamp will light up

and the winder may not function; this does not mean it is

out of order. In this case, manually wind the film advance

lever once.