Owner manual

REPORT SETTINGS
Factory settings arc in hold.
For instructions on how to change a setting, refer to Flow to change a setting,pgs.8.f-86.
Name
Description
Settings 1
TX REPORT
Enable/disable automatic printing of the transmission report.
PRINT ERROR ONLY prints only when a transmission error
occurs.
OUTPUT YES sets the FAXPHONE to print an activity report
every time you send a document,
OUTPUT NO turns off the activity report feature.
OUTPUT YES/OUTPUT NO
/PRINT ERROR ONEY
TX CONFIRM REP.
Add to the TX report half of the first page of the document that
was being sent. This can help remind you which document was
being sent. Valid only for memory transmissions.
OUTPUT YES/OUTPUT NO
RX REPORT
Enable/disable automatic printing of the reception report.
PRINT ERROR ONLY prints only when an error occurs during
receiving,
OUTPUT YES sets the FAXPHONE to print an activity report
every time you receive a document.
OUTPUT NO turns off the activity report feature.
OUTPUT YES/OUTPUT NO
/PRINT ERROR ONLY
ACTIVITY REPORT
Unless you change the setting, your FAXPHONE is set to print an
activity management report for every 20 transactions (sending or
receiving).
AUTO PRINT
Enable/disable automatic printing of the activity report.
OUTPUT YES/OUTPUT NO
TX/RX SEPARATE
Divide the activity management report into sending and
receiving transactions
ON/OFF
INKSAVER
Enable/disable economy printing (ink saving feature) when
printing reports
By enabling the INKSAVER mode, ink consumption can be
decreased by as much as fifty percent, resulting in a longer
effective cartridge life.
ON/OFF
1 TX SETTINGS 1
Factor) settings are in bold.
For insu’uclions on how to change a setting, refer to Flow to change a setting, pgs.83-86.
1 Name
Description
Settings \
ECM TX
Enable/disable error correction during transmission.
ON/OFF
MID PAUSE SET
Set the length of the pause you insert into a dialing sequence.
2 seconds (1 to 15)
AUTO REDIAL
Set the number of times the FAXPHONE will redial a number if it
fails to get a response on the first attempt, and the interval
between redial attempts.
ON/OFF
REDIAL TIMES
Set the number of retries.
2 times (1 to 10)
REDIAL INTERVAL
Set the period of time between redialings.
2 minutes (1 to 60)
88