Owner manual

Registering your name and number

5 After selecting or entering a value, press [START/

COPY],

START/COPY

DATA ENTRY OK

Repeat steps 4 and 5 as needed.

When the operation is complete, press [STOP],

Registration ends and the I'AXPHONEi leltims to

standhv mode.

STOP

After fit) see. w ith no operation panel input, the FAXPHONE returns to

standby mode and anv unrecistcred changes are lost.

Entering a number

Whenex er you are prompted to enter a lax number or a telephone number, follow these

procedures.

Use the numeric buttons to enter the number.

TEL=

I You can enter up to 20 digits for your fax number or 100 digits for a speed dialing

n umber.

I Be sure to enter I and the area code, if necessary, to dial a different area code.

I Do not enter dashes, slashes, commas, or other punctuation.

f.'se the one-touch speed dialing buttons as follows:

I To enter a space between numbers, press |.SPACE|.

I If you make a mistake, press 1CLHAR| and enter the number again.

I To erase a pre\ iously registered number, press |CEEAR|. You can also enter a new

number oxer the old one.

’ you need to enter a pause for any reason.

Press IP.ALJSEl at the desired point in the sequence when entering a series of

digits.

\ pause w ithin a number is 2 seconds long. The length of this pause can be

adjusted, see MID PAUSE SET in TX SETTINGS, pg.88. A pause at the end of

a number is fixed at 10 seconds.

, "

;/:з

...

‘

:з

ЬС

rr.:C;.S ...