Owner manual

Jsers in Canada
PRE-INSTALLATION REQUIREMENTS FOR CANON FACSIMILE EQUIPMENT
A. Location
Supply a suitable table, cabinet, or desk. See specifications (pg,113) for unit’s dimensions and weight,
B. Order Information
1, Provide only a single line to touch-tone or rotary telephone set terminated with a standard 4-pin
modular phone plug, (Touch-tone is recommended if available in your area,)
2, Order an RJ11-C modular jack (USOC code), which should be installed by the phone company. If
the RJ11 -C lack is not present, installation cannot occur,
3, Order a normal business line from your telephone company’s business representative. The line
should be a regular voice grade line or equivalent. Use one line per unit.
DDD (DIRECT DISTANCE DIAL) LINE
or
IDDD (INTERNATIONAL DIRECT DISTANCE DIAL) LINE IE YOU
COMMUNICATE OVERSEAS
NOTE: Canon recommends an individual line following industry standards [e.g,, the 2500 (Touch tone)
or 500 (Rotary/Puise Dial) telephones], A dedicated extension off a PBX unit without “Camp
On' signals is also permissible with a FAX unit. Key telephone systems are not recommended
because they send non-standard signals to individual telephones for ringing and special
codes, which may cause a FAX error
C. Power Requirements
The power outlet should be a three-prong grounded receptacle (Single or Duplex). It should be
nuependent fromi copiers, heaters, air conditioners, or any electric equipment that is thermostatically
controlled The mted value is 120 volts and 15 amperes. The RJ11-C modular jack should be relatively
close to the power outlet to facilitate installation
NOTICE
Tne Inoustry Canada label identifies certified equipment. This certification means that the equipment meets
ertain telecommunicatmns networks protective, operational and safety requirements. The Department does
ot guarantee the equiomen' will operate to the user s satisfaction.
Before installing this equipmipiit. users should ensure that it is permissible to be connected to the facilities ot
rne local telecomimiunicatioi's comoany The equipment must also be installed using an acceptable method of
connection In some cases the comoany's Inside wiring associated with a single line individual service may
be extended by means o‘ a certTied connector assembly (telephone extension cord). The customer should be
aware tnat compliance W'th ne abcve ccnditions may not prevent degradation of service in some situations.
The Load Number (LN) assigned to each terminal device denotes the percentage of the total load to be
connected to a telephone loop which is used by the device, to prevent overloading. The termination on a loop
may consist of any combination of devices sub|ect only to the requirements that the total of the Load Numbers
of ai! the devices does not exceed 100.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility designated
bv tne supplier Any repairs or alterations made by the user to this equipment, or equipment malfunctions,
may give tne telecommunicaticns cempany cause to request the user to disconnect the equipment
nformation regarding authorized service facility locations can be obtained by calling Canon Canada below.
CANON CANADA
1-800-263-1121
24 HOURS A DAY, 7 DAYS A WEEK
Users snould ensure for their own protection that the electrical ground connections power utility, telephone
fees and internal metallic water pipe system, if present, are connected together. This precaution may be
particularly important in rural areas.
Caution
Users should not attempt to make such connections themselves, but should contact the appropriate electric
nspect^on authority, or electrician, as appropriate.
This digital apparatus does not exceed the Class B limits for radio noise emissions from digital apparatus set
i';ut in the Radio interference Regulations of fhe Canadian Department of Communications.