Fax Machine Users Guide
Table Of Contents
- Using this guide
- Important safety instructions
- For your safety (Australia only)
- Caution (New Zealand only)
- SETTING UP
- PREPARING TO USE YOUR FAX
- Main components of your fax
- Fax controls - the operation panel
- Guidelines for entering numbers, letters, and symbols
- Setting the TEL LINE TYPE
- Dialing through a switchboard (PBX)
- Registering sender information
- Registering one-touch speed dialing numbers and names
- Registering coded speed dialing numbers and names
- Registering UCanTalk voice tags
- DOCUMENTS AND PAPER
- MAKING COPIES
- SENDING DOCUMENTS
- RECEIVING DOCUMENTS
- USING TAM MODE (FAX-B840 only)
- SETTINGS AND ACTIVITY REPORTS
- SOLUTIONS TO COMMON PROBLEMS
- Specifications
- Index
6-6
* Exclude UCanTalk.
Setting CALLER ID
If the CALLER ID setting is set to ON, the caller’s name and phone/fax number appear on the
LCD when you receive a call. You can also set the fax to reject unwanted calls (FAX-B840
only).
1
Press [Function].
Press [Polling].
Press [Start/Copy].
2
Dial the fax number of the fax machine you wish to poll.
Use one of the dialing methods* described on page 5-2.
3
Press [Start/Copy].
Your fax begins receiving the document.
• CALLER ID is only available in some countries.
• To use this feature, you will need to subscribe for a Caller ID service (only available in some
countries). The Caller ID feature uses the ETSI EN 300 778-1 protocol. Contact your local
telephone company for detailed information on this service.
1
Press [Function].
Press [Start/Copy].
2
Use [ ] or [ ] to select CALLER ID.
Press [Start/Copy].
• To disable Caller ID feature, use [ ] or [ ] to select OFF, then press [Start/Copy]. Press [Stop] to
return to standby mode.
• To enable Caller ID feature, use [ ] or [ ] to select ON and continue with the steps below.
3
Press [Start/Copy].
TEL= 3456xxxx
OFF