Technical information

Prepare the printer.
Make sure the printer is turned
on.
Make sure the paper support is
not extended.
Make sure the paper thickness
lever is pressed to the up
position
Pull out the paper output tray
and its extension.
Prepare the banner paper.
Cut the banner at a crease according
to the length you need.
The minimum length is two sheets.
The maximum length you can use is
six sheets (66 inches or 1676 mm).
Always leave an extra sheet at
the end of the banner—just in
case the type runs over.
Load the first sheet.
Align the first sheet of the
paper with the right edge of
the sheet feeder and slide it
into the printer until it stops.
Adjust the paper guide to the
left side of the sheet.
Fold the banner paper.
Paper Handling
Chapter 3 Paper Handling 3-21