Technical information

Paper Does Not Feed From Sheet Feeder
Paper is too thick Feed manually
Paper within the range of 17 to 24 lb (64 to 105 g/m
2
)
can be loaded in the sheet feeder. Thicker paper must
be fed manually one at a time from the back of the
printer. The printer does not support paper thicker
than 0.6 mm.
Sheet feeder Check sheet feeder capacity
overloaded Check that you do not exceed the sheet feeder capacity.
Paper will not feed correctly if you exceed the specified
number of sheets. (See page 3-5.)
Paper support not Raise the paper support
raised The paper support should be raised unless you are
loading envelopes.If the paper support is not raised,
the media will not slide fully into the paper feed slot
and will not feed into the printer correctly.
Paper wrinkled or Check that you are using appropriate media
curled Paper that is folded, curled, or crumpled will not feed
into the printer correctly, and may also cause paper
jams.
Auto Feeder not Select Auto Feeder
selected in the Open the Printer Properties dialog box. On the
printer driver Main tab,click the Advanced button. On the Quality
tab, click the Paper Feed down-arrow and select Auto
Feeder from the pull-down list.
See page 5-16 for details on clearing a paper jam.
Troubleshooting
Chapter 5 Troubleshooting 5-5