Operation Manual

2.3.3 Reattaching and removing the upper cover unit
Procedures to reattach the upper cover unit are shown below:
1) Assemble the back part of the upper cover unit.
2) Assemble the claw on the front side.
To remove the cover, follow the procedures in reverse order.
2.3.4 Removing the printer unit
Procedures to remove the printer unit are shown below:
1) Remove the screws which fasten the printer unit to the bottom case.
2) Release the 2 claws on the bottom case on the back side of the printer unit (Arrows
1 and 2).
3) Holding the handles on both sides of the printer, shift and raise the printer unit as
by Arrow 3.
Part 2: Maintenance
BJC-3000
2-8
2
1
Figure 2-7 Reattaching and Removing the Upper Cover Unit
Figure 2-8 Removing the Printer Unit
1
2
3
3
Screw