Operation Manual

2.3.5 Removing the pressure roller unit
To remove the pressure-roller unit, release the three claws in the order shown in the
figure, and pull to the back side of the printer unit and remove.
Claws can be undone with ease when removed from the left side of the printer.
2.3.6 Position of spurs in the spur base unit
The positions of spurs on the spur base unit are shown below (seen from the bottom,
from which the spurs will be re-installed).
Re-install the spurs in the correct position if they are accidentally dislocated.
2-9
BJC-3000
Part 2: Maintenance
Maintenance
Figure 2-9 Removing the Pressure Roller Unit
Figure 2-10 Position of Spurs in the Spur Base Unit (Bottom View)
Position of spurs
Position of spurs