Operation Manual

2-11
BJC-3000
Part 2: Maintenance
Maintenance
2.4 Grease Application
This printer requires only 1 type of grease, MOLYKOTE PG-641 (CK-0562).
The points to apply the grease are shown below.
Use the flat brush to apply grease evenly.
Refer to the Parts Catalog for disassembly/reassembly procedures.
Make sure that grease does not contact the wiper or the head cap.
Figure 2-13 Grease Application Points
CAUTION
Carriage Shaft Sliding Surface
(apply the proper amount of grease
so as not to drop)
Approx. 200mg (Molykote PG-641)
Carriage Guide Frame Back Surface
(apply a thin coat of grease over the entire surface)
Approx. 200mg (Molykote PG-641)
Feed Roller Sliding Surface
(3 locations at the back of the platen)
Approx. 14mg each (Molykote PG-641)
Cam Sliding Surface
Approx. 27mg (Molykote PG-641)
Pick-up Roller Sliding Surface
Approx. 7mg (Molykote PG-641)