Operation Manual

2.5.2 When adjustment of the print head position is required

When replacing the print head, good print quality may not be obtainable due to

changes in the dot placement points caused by the individual differences and the

installation state of the BJ cartridge. To prevent this misalignment, use the printer

driver utility to conduct the automatic head position adjustment after the BJ cartridge

is installed. Set a sheet of A4/LTR-sized plain paper and perform the head position

adjustment pattern in [Test print] in the printer driver's [Maintenance].

Be sure to set A4/LTR-sized paper in the ASF before printing the head

position adjustment pattern. Using printing paper smaller than the

printing area of the data when performing the head position adjustment

print will contaminate the platen with ink.

2-13

BJC-3000

Part 2: Maintenance

Maintenance

(B1) -6 -5 -4 -3 -2 -1

-1 +10

0+1+2+3+4+5+6+7-7

(B2)

(B1)

(B2)

-6 -5 -4 -3 -2 -1 0 +1 +2 +3 +4 +5 +6 +7-7

CAUTION

Figure 2-14 Print Position Adjustment Patterns