Operation Manual
2. SERVICE FUNCTIONS
This printer provides a service mode to output a test printout, to set up and confirm the
service. Button operation is used to switch to this mode.
2.1 Service Mode Operations
1) When the power is turned off, while holding down the
RESUME
button, press and
hold the
POWER button
. The green indicator will light up.
2) While holding down the
POWER button
, release the
RESUME
button. Then double-click
the
RESUME
button and release the
POWER button
.
(The indicator blinks in orange/green every time the
RESUME
button is pressed.)
3) The green indicator blinks while initial operations are in progress. When the
indicator lights (stops blinking), press the
RESUME
button to select one of the
followings.
(The indicator blinks in orange/green every time the
RESUME
button is pressed.)
Press Indicator Functions
0 times Lights in Green Service/factory test print
1 time Lights in Orange EEPROM information print
2 times Lights in Green EEPROM initialization (Clears the settings to the factory
default, except the model settings)
3 times Lights in Orange Waste ink counter reset
4 times Lights in Green Model setting *: for details, see below
5 times Lights in Orange Ink presence check; Readout data print
6 times Lights in Orange Power off/carriage lock
or more
4) Execute the function you have selected by pressing the
POWER
button. The indicator
will light in green, and the operation will be executed.
(The printer will turn off after the operation has completed.)
* : If Model setting is selected, the
RESUME
button is to be pressed the appropriate
number of times shown below.
(The green indicator blinks during the initial operation. The indicator will light in
orange/green every time the
RESUME
button is pressed.)
Press Indicator Model
0 time Lights in Green BJ F300
1 time Lights in Orange BJC-3000
2 times --- Reserved (setting will not change).
or more
After making your selection, press the
POWER
button to enable the new setting.
(The printer will turn off when the operation is completed.)
Be sure to install a BJ cartridge prior to operations in the service mode, as
it is not possible to enter service mode otherwise. Confirm the model
settings with the service/factory test print if they have been changed.
Part 3: Operation
BJC-3000
3-8
CAUTION