Specifications

Getting Started
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
1-9
Push the UTILITY button, then push the System bottom button to select I/O.
The oscilloscope displays the I/O menu, as shown in Figure 1--8, which contains
the Ethernet Network Settings and Ethernet Printer Settings bottom buttons.
Figure 1- 8: The Ethernet Network Settings menu
Ethernet Network Sett ings Menu. Figure 1--9 shows the Ethernet Change
Instrument Settings screen. Table 1--2 describes the Ethernet Network Settings
fields. The procedures on page 1--13 (for networks that support DHC P/BOOTP)
and 1--14 (for networks that do not support DHCP/BOOTP) describe how to set
up the oscilloscope to communicate on your network using the appropriate
instrument IP information from your network administrator.
The Ethernet Menus