Specifications

Getting Started
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
1-15
H The Back Space button deletes the character to the left of the cursor
position in the field.
H The Delete button deletes the character at the cursor position in the field.
H The Clear button deletes all characters from the current field.
9. Push the OK Accept side button to apply the field settings. Push the MENU
OFF button to exit from the menu without applying any changes.
10. Push the Test Connection side menu button to verify that the Ethernet
settings are correct and that the oscilloscope can locate itself on the network.
11. If the oscilloscope does not establish a connection to the network, check that
you correctly entered the Ethernet instrument settings, and that you have
connected the oscilloscope to the Ethernet connector with an appropriate
10baseT cable. If the settings and cable are correct, contact your network
administrator for help.
Ethernet Printer Settings. This procedure presumes that you have successfully
established communications with the network by using one of the previous
procedures.
Do these steps to add a network printer to the oscilloscope (you can store up to
21 printers in the Ethernet network printer list):
1. Obtain the printer name, server name, and server IP address of the network
printer or printers to which you are sending hard copy data.
2. Power on the oscilloscope.
3. Push the UTILITY menu button.
4. Push the System screen button and select the I/O System.
5. Push the Ethernet Printer Settings screen button. The oscilloscope displays
the Printer Configuration window, as shown in Figure 1--10.
6. Push the Add Printer screen button to display the Add Printer dialog box.
7. Push the side menu ↑and ↓ buttons to select a field to edit.
8. Enter the required information into each field:
H The general purpose knob selects a character in the character list. The list
of available characters changes depending on which field is selected.
H The Enter Character button enters the selected character from the
character list. You can also use the SELECT button next to the general
purpose knob to enter the selected character.
H The ← and → buttons move the cursor left or right in the current field.