Specifications

Status and Events
TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
3-17
Table 3- 5: Execution error messages - EXE Bit 4 (Cont .)
Code Message
2276 Alias expansion error
2277 Alias redefinition not allowed
2278 Alias header not found
2279 Alias label too long
2280 Alias table full
2285 TekSecureR Pass
2286 TekSecureR Fail
2301 Cursor error, Off -screen
2302 Cursor error, cursors are off
2303 Cursor error, Cursor source waveform is off
Table 3--6 lists the device errors that can occur during oscilloscope operation.
These errors may indicate that the oscilloscope needs repair.
Table 3- 6: Device error messages - DDE Bit 3
Code Message
300 Device-specific error
310 System error
311 Memory error
312 PUD memory lost
313 Calibration memory lost
314 Save/recall memory lost
315 Configuration memory lost
316 Password memory lost
350 Queue overflow (does not set DDE bit)
361 Parity error in program message (check parity)
362 Framing error in program message (check baud rate)
363 Input buffer overrun (check flagging)