Specifications

TDS3000, TDS3000B, and TDS3000C Series Programmer Manual
2-11
Command G roups
This section lists TDS3000, TDS3000B, and TDS3000C Series GPIB commands
in two ways. It first presents them by functional groups. It then lists them
alphabetically. The functional group list starts below. The alphabetical list
provides more detail on each command and starts on page 2--45.
The GPIB and RS-232 interfaces conform to Tektronix standard codes and
formats except where noted. The GPIB interface also conforms to IEEE Std
488.2-1987 except where noted.
Acquisition Commands
Acquisition commands affect waveform acquisition. These commands control
autoset mode, averaging, enveloping, and waveform acquisition. (Persistence
controls are in the Display Commands section on page 2--16.) Table 2--4 lists
these commands.
Table 2- 4: Acquisition commands
Header Description
ACQuire? Return acquisition parameters
ACQuire:MODe Acquisition mode
ACQuire:NUMACq? Return # of acquisitions obtained
ACQuire:NUMAVg Number of acquisitions for average
ACQuire:NUMEnv Number of acquisitions for envelope
ACQuire:STATE Start or stop acquisition system
ACQuire:STOPAfter Acquisition control
AUTOSet Automatic instrument waveform acquisition
setup
WAVEAlert:BEEP
(TDS3000B and TDS3000C Series)
Sets or returns the WaveAlert Beep on
Anomaly function
WAVEAlert:hard copy
(TDS3000B and TDS3000C Series)
Sets or returns the WaveAlert print Hard Copy
on Anomaly function
WAVEAlert:SAVEWFM
(TDS3000B and TDS3000C Series)
Sets or returns the WaveAlert Save Waveform
to memory on Anomaly function
WAVEAlert:SENSitivity
(TDS3000B and TDS3000C Series)
Sets or returns the WaveAlert Anomaly
sensitivity function