Operation Manual

59
Preparing the Envelopes
This section explains how to prepare the envelopes before loading them into the paper drawer.
Using curled, creased, or folded envelopes may cause paper jams. Load envelopes after following the procedure below
1
1
Neatly align the envelopes.
1. Place the envelopes on a clean,
level surface, and press all the way
around the envelopes by hand,
in the direction of the arrows, to
remove any curls.
Repeat this step ve times for each set
of ve envelopes.
2
2
Hold down the four corners of the envelopes rmly, so that they and the sealed
or glued portion stay at.
Flap
Flap
If you use envelopes that have glue attached to their aps, the glue may melt due to the heat and
pressure of the xing unit.
Take particular care to spread the envelopes out in the direction that they will be fed.
Do not print on the back side of the envelopes (the side with the ap).
If the envelopes become lled with air, atten them by hand before loading them into the envelope
feeder attachment.
•
•
•
•