User`s manual

7-20
Upgrading the Firmware Remotely
Note
● Do not turn the power off until you have confirmed that the VB-C50FSi/VB-C50Fi
has restarted. Turning the power off before completion may prevent it from starting
up properly.
● Upgrading the firmware deletes all saved web page data (→ P.5-8). Back up your
data before using this function.
Get the new firmware from Canon Web site, and upgrade in command prompt. The firmware file
is called “Firmware_new.bin” and is saved on your PC in “My Documents”.
1. Open command prompt.
C:\Documents and Settings\xxxx> is displayed on the screen.
2. Specify the folder containing the firmware.
Enter: C:\Documents and Settings\xxxx>cd My Documents
3. Use the ftp command and connect to the VB-C50FSi/VB-C50Fi.
Enter: C:\Documents and Settings\xxxx\My Documents>ftp 192.168.100.1
4. Enter Administrator account and password.
Enter: User (192.168.100.1: (none)): root
Password: VB-C50i
* Enter the password you are actually using. For more details about changing passwords,
please refer to “Setting Up the Administrator Password and Ethernet etc.” (→ P.3-5).
5. Change to binary mode.
Enter: ftp> binary
6. Send the firmware to the VB-C50FSi/VB-C50Fi.
Enter: ftp> put Firmware_new.bin flash
7. Transmission begins.
It normally takes 1-2 minutes to complete transmission.
8. Notification of completion.
“The system upgraded completed successfully” is displayed.
9. Log out of the VB-C50FSi/VB-C50Fi and close command prompt.
Enter: ftp> bye
C:\Documents and Settings\xxxx\My Documents> exit
Tip
● The underlined portion is a sample IP address. Enter the actual IP address that
was set on the VB-C50FSi/VB-C50Fi (→ P.3-6).
● The user name logged onto the PC is displayed in “xxxx”.
COPY