Service manual

G37

-In the play mode, press the MENU button to display the Play Menu.

-Select "Single Erase" or "Erase All", then press the SET button.

-When Single Erase has been selected, the image displayed before the Play Menu appeared will be displayed. Press the

Omni Selector to select the image to be erased. Then press the SET button. A confirmation message will be displayed.

Select "OK" and press the SET button. If "Erase All" is selected, the confirmation message will appear immediately.

Select "OK" and press the SET button.

-Press the * (AE Lock) button to set the short cut for single erase.

-In the play mode, press the MENU button to display the Play Menu. Select "Rotate".

-When the target image is displayed, pressing the SET button rotates the image to the angle of (0, 90, 270 ) degree.

-Press the MENU button to fix.

<Image-protect>

-On the Playback menu, select "Protect" and press the SET button.

-When the target image is displayed, pressing the SET button sets the image-protect. (If the image is already protected, the

image-protect will be canceled.)

-While in the play mode, press the MENU button to display the Play Menu. On this menu, select Slide Show and then

press the SET button.

-Select “Start” and press the SET button.

-To display all the images in numeric order, select "All Images." To display only the previously marked images in the

specified order, select "Show 1-3."

-Marking Images

1.On the Slide Show menu, select "Show 1-3" and then press the SET button. Select "Select" and then press the SET

button.

2.Single image will be displayed. To mark an image, use the Omni Selector (LEFT/RIGHT) to select the image and

then press the Omni Selector (UP). A number will then appear on the marked image. To remove the check mark,

select the marked image and then press the Omni Selector (DOWN) button to unmark the image, then press the

MENU button.

-To set the play time or to repeat the slide show, use the Set up menu.

-After selecting the play mode, select "Start" and press the SET button to start the Slide Show.

-On the Playback menu, select "Print order" and press the SET button.

-Below the current settings displayed, select "Order," "Set up," or "Reset," then press the SET button.

-When you select "Order," press the Omni Selector to display the images. Then press the SET button to so you can specify

the number of copies. The current number will be displayed. Press the Omni Selector to change the number.

-When you select "Set up," set the print type, date, and file No. imprint, then press the SET button.

-To reset all the settings to the default, select "Reset" and press the SET button and select "OK." The image selection will

also be cleared.

-Use the A/V cable (provided) to connect the TV’s video IN and sound IN terminal to the camera’s A/V OUT terminal.

-Set the camera's Mode Switch to PLAY to display the image on the TV monitor.

-Press the Index button to select Single or Multi.