Operation Manual

Change the use of separator sheets

Introduction

Separator sheets are empty sheets that are automatically inserted before each new set or

job to separate two sets or jobs. In the Settings Editor you can define the media that must

be used as separator sheets. The use of separator sheets can be enabled via the automated

workflows in the Settings Editor. However, you can change this setting trough the oper-

ator panel.

How to change the use of separator sheets

Touch 'Jobs' -> 'Waiting jobs'.

Touch the job of which you want to change the settings.

NOTE

You can only change the settings of the active print job after you stopped the

printer (press the 'Stop' button two times).

Press 'Properties'.

Touch the 'Separator sheets' button to toggle between 'On' and 'Off'.

Press 'OK'.

•Introduction to automated workflows, on page 331

Chapter 6 - Print jobs154

Change the use of separator sheets