Operation Manual

Clean the wire
Introduction
If streaks appear on printed output or parts of the printed image are missing, clean the
corona assembly wires inside the main unit.
#
NOTE
•
It takes approximately 35 seconds to clean the wires.
•
Wire cleaning cannot be performed during printing.
Clean the wire
1.
Touch 'System' -> 'Maintenance'.
2.
Press 'Start maintenance'.
3.
Touch 'Clean the corona wires' and touch 'Start' .
A wizard opens.
4.
Press 'Next'.
A status message displays.
5.
Press 'Finish'.
6.
Touch 'Stop' to close the 'Maintenance tasks' menu.
Result
If the procedure displays an engine error, contact your local service representative.
Chapter 11 - Maintenance and calibration352
Clean the wire