VB-C60 Manual
Table Of Contents
- Introduction
- Contents
- How to Read This Document
- Top Page of the Camera
- Chapter 1 Detailed Settings
- Setting Menu
- Accessing the Setting Menu
- Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
- Setting the Date and Time (Date and Time)
- Setting the Camera Control and External Device Name (Camera)
- Setting the Image Size, Quality and Frame Rate (Video)
- Setting HTTP/FTP Upload and E-mail Notification (Upload)
- Setting the Image Server, Audio Server and HTTP Server (Server)
- Setting the Image Buffer, Motion Detection, Audio Playback and Interval Timer (Event)
- Setting User Access Privileges (Access Control)
- IPsec Settings (IPsec)
- Setting the Items Requiring Rebooting (Reboot Item)
- Viewing Event Logs and Current Settings, and Performing Maintenance (Maintenance)
- Chapter 2 VBAdmin Tools
- Chapter 3 VB-C60 Viewer
- Chapter 4 Creating Web Pages for Video Distribution
- Chapter 5 Appendix
5-14
List of Log Messages
B102 Client connection denied [notice]
B103 Client forcibly disconnected [notice]
B301 Audio sending device error [err]
B401 Audio device initialization failed [crit]
Description %1 request denied[%2] (B102)
%1 Client host IP address
%2 Denial type (41 | 43 | ...)
Meaning
Client connection was denied due to an authentication error (41),
insufficient resource (43), specification of unsupported codec (45),
specification of unsupported stream (46), host access restriction (48), too
many clients (49) or invalid operation mode (4a).
Countermeasure
41: Check the user name, password or user list used for connection, 43:
Reconnect or reboot the camera, 45 or 46: Use supported client software,
48: Check the host access restriction, 49: Check the maximum number of
clients that can be connected, 4a: Check the applicable settings to see if
the audio server is used.
Description %1 access denied[%2] (B103)
%1 Client host IP address
%2 Denial type (41 | 48 | 4a)
Meaning
Connection was initially permitted, but the setting has subsequently been
changed to prohibit access, thereby triggering a forced disconnection (the
denial type is the same with B102).
Description cannot use audio device for tx[%1:%2] (B301)
%1 Error handling (ld | buff)
%2 Error number
Meaning An audio device error was detected.
Countermeasure
If the error is not reset automatically, arrange for servicing.
Description audio device initialization error[%1] (B401)
%1 Error number
Meaning The audio device could not be initialized. The audio server stops.
Countermeasure
If the problem persists after rebooting, the camera is faulty. Arrange for
servicing.