VB-C60 Manual
Table Of Contents
- Introduction
- Contents
- How to Read This Document
- Top Page of the Camera
- Chapter 1 Detailed Settings
- Setting Menu
- Accessing the Setting Menu
- Setting the Administrator Password, LAN, IPv6, DNS, etc. (Network)
- Setting the Date and Time (Date and Time)
- Setting the Camera Control and External Device Name (Camera)
- Setting the Image Size, Quality and Frame Rate (Video)
- Setting HTTP/FTP Upload and E-mail Notification (Upload)
- Setting the Image Server, Audio Server and HTTP Server (Server)
- Setting the Image Buffer, Motion Detection, Audio Playback and Interval Timer (Event)
- Setting User Access Privileges (Access Control)
- IPsec Settings (IPsec)
- Setting the Items Requiring Rebooting (Reboot Item)
- Viewing Event Logs and Current Settings, and Performing Maintenance (Maintenance)
- Chapter 2 VBAdmin Tools
- Chapter 3 VB-C60 Viewer
- Chapter 4 Creating Web Pages for Video Distribution
- Chapter 5 Appendix
1-47
IPsec Settings (IPsec)
1
1
Detailed Settings
If [AH] or [ESP and AH] was set under [Security Protocol] in (5), the following items must be
set.
(16)
[SA AH Authentication Algorithm]
Select [HMAC_SHA1_96] or [HMAC_MD5_96] as the AH authentication algorithm according
to the authentication algorithm supported by the device to connect to.
(17)
[SA AH Authentication key (outbound)]
Set the SA authentication key for outbound. If [HMAC_SHA1_96] or [HMAC_MD5_96] was set in
(16), set a 160-bit or 128-bit hexadecimal, respectively.
(18)
[SA AH SPI (outbound)]
Set the SA SPI value for outbound. Set a desired value in a range of 256 to 4294967295.
(19)
[SA AH Authentication key (inbound)]
Set the SA authentication key for inbound. If [HMAC_SHA1_96] or [HMAC_MD5_96] was set in
(16), set a 160-bit or 128-bit hexadecimal, respectively.
(20)
[SA AH SPI (inbound)]
Set the SA SPI value for inbound. Set a desired value in a range of 256 to 4294967295. Since
this setting is used as an ID for identifying the SA, be careful not to specify an inbound SPI
whose value is already used as the SPI for another ESP.
Note
z To use this camera using IPsec, the communicating destinations and network must be set
beforehand. For these settings, contact your System Administrator.
z If you change any setting from the [IPsec] menu, the active browser may become unable to
connect to the camera. Check beforehand the precautions explained in "Notes" in "Setting
the Items Requiring Rebooting (Reboot Item)" ( P. 1-49).