Quick Start Guide

12
Scanning Film
You can scan 35 mm film (film strips or slides) with this scanner.
Positioning the Film
Use the following procedures to insert the film into the film guide.
1
Remove the protective sheet from the document cover.
Fit the holes at the bottom end of the protective sheet over the posts at the bottom of the document
cover and slide the protective sheet down. Repeat the procedure for the top end.
2
Insert the film into the film guide.
Film Strips
Open the film holder on the film guide for film strips, insert
the strip(s) face down and close the film holder.
Slides
Place a slide or slides face down in the film guide for slides as
shown in the diagram to the right.
• Store the protective sheet in a safe place so that it will not get bent or broken.
• Always replace the protective sheet when you are not scanning film to prevent the
light source section from getting scratched.
• Place a black piece of paper over any gap
to shield the light if you are inserting a film
strip with 5 or fewer frames, or if the edge
of a scanned image appears whitened.
cd
Slide the
protective sheet
up and out to
free it from the
tabs at the top.
ef
Slide the sheet
up again and
out to free it
from the tabs at
the bottom.